BASEstartm Open DAS
for Modicon®
on Tru64tm UNIX®
Installation and User's Guide


Previous Contents Index

2.3.5 Tracing Device Communications

The DAS for Modicon programmable controllers has built into it the capablity to trace device communications and to send this output to either a file or to a user terminal. The purpose of this tracing is to allow the troubleshooting of device communications.

Tracing can be enabled for a device and/or a line. If tracing is enabled for a device, then only communications from/to that device are traced. If tracing is enabled for a line, then all communications from/to that line are traced. If both device and line tracing is enabled, then the trace will contain the output for both the device and the line, so the trace output will be duplicated.

To enable tracing do the following:

The trace output is flushed to the file after every 10 lines that are traced, so trace output may lag actual device I/O.

All trace output is in hexadecimal and shows both input to and output from the device.

To turn tracing off, reverse the steps used to turn tracing on.

2.4 Failures During Product Use

If an error occurs while this product is in use and you believe the error is caused by a problem with the product, take one of the following actions:

When you submit an SPR, take the following steps:

  1. Describe as accurately as possible the circumstances and state of the system when the problem occurred. Include the description and version number of the product being used. Demonstrate the problem with specific examples.
  2. Reduce the problem to as small a size as possible.
  3. Remember to include listings of any command files, INCLUDE files, or relevant data files, and so forth.
  4. Report only one problem per SPR. This will facilitate a faster response.
  5. Mail the SPR package to Compaq.


Previous Next Contents Index