SOFTPAQ NUMBER: SP4806 PART NUMBER: N/A FILE NAME: N/A TITLE: Deskpro 2000MMX/4000MMX S3 Display Support for NT 4.0 VERSION: 3.21 Rev A LANGUAGE: Norwegian CATEGORY: Desktops/Drivers PRODUCTS AFFECTED: Deskpro 2000MMX/4000MMX Series with with one of the graphics controllers listed below. NOTE: To determine whether your unit has the video controller supported by this driver, go to Control Panel/Display /Settings/Display Type. OPERATING SYSTEM: Microsoft Windows NT 4.0 SYSTEM CONFIGURATION: Using one of the following graphics controllers: S3 V2/GX S3 ViRGE/GX Cirrus 5434 Cirrus 5436 Cirrus 5446 QVision 1280/P QVision 1280/P+ EFFECTIVE DATE: 29 September 1997 ELECTRONIC DISTRIBUTION ALLOWED: Yes SUPERSEDES: SP3916 DESCRIPTION: This SoftPaq unpacks the files required to install the video driver for Windows NT 4.0 for the S3 V2/GX or ViRGE/GX controller used in certain Deskpro 2000MMX/4000MMX models.It also supports previous Cirrus 5434/36/46 and Qvision 1280/P and 1280/P+ graphics controllers. Optionally allows a driver diskette to be created. Enhancements/Fixes: This version addresses certain Microsoft Hardware Compatibility Test (HCT) failures occuring on higher speed computers, and also corrects a problem that prevents the RealMagic Pro MPEG adapter from displaying video streams. HOW TO USE: 1. Download the SoftPaq to a temporary, empty directory on your hard drive. The file downloaded is a self-extracting executable with a filename based on the SoftPaq Number above. 2. From the download directory, execute the SoftPaq. When executed with no parameters, files are extracted into the current directory. To extract the files into a different directory, specify the complete path of the directory as a parameter: SPxxxx Enter "Y" to confirm and files are unpacked into the download directory or the directory specified. 3. After the files have been created, you may delete the self-extracting file downloaded in step 1. 4. The driver may be installed directly from the files on the download directory or driver diskette can be created. To create a driver diskette, run MAKEDISK.BAT. To install the driver, go to the Control Panel and select: Display/Settings/Display Type Verify that the Adapter Type is one of the ones listed above. If it is not, then cancel and exit. If it is, then continue to select: Change/Have Disk Type in the path to the download directory or select "Browse" to specify the location of the files extracted in step 2. 5. Select OK to install the driver. 6. After the driver has been installed, you may delete the files from the download directory if you wish. Copyright 1997, Compaq Computer Corporation. All rights reserved. Product names mentioned herein may be trademarks and/or registered trademarks of their respective companies